A practical reference on impurity profiling: what it is, how it behaves, what the literature reports, and where the honest uncertainties sit.
Reviewed 2026-07-20. Anything still debated is marked as such rather than presented as settled.
Quality control includes system suitability, blank injections, and reference standards. System suitability checks column performance and retention time reproducibility, while blank runs detect carryover or mobile-phase contaminants. Reference standards help calibrate retention time and detector response. Without these controls, a purity value is difficult to compare across laboratories or over time. Documentation of instrument settings and integration parameters is also part of quality control, and acceptance criteria should be set before samples are analyzed.
Impurity profiles can include deletion peptides, oxidized forms, truncated sequences, and residual solvents. Some impurities arise during synthesis, cleavage, or purification, while others form during storage. Purity testing often focuses on peptide-related impurities, whereas residual solvents and counterions require separate assays. The significance of a given impurity depends on its amount and properties, which may not be established for a research peptide. Reporting an impurity profile is more informative than reporting a single purity number.
Impurity profiling identifies and quantifies substances that coexist with the target peptide. These include deletion sequences, truncated peptides, oxidized variants, and residual protecting groups from synthesis. Reversed-phase chromatography can separate many of these impurities, but co-elution remains a challenge for closely related species. Mass spectrometry helps assign identities to impurity peaks, and impurity limits are often set as area percentages relative to the main peak. Regulatory guidelines for research-grade peptides are less strict than those for therapeutic products, so specifications vary by supplier.
Quality control for peptides involves setting specifications for identity, purity, and counterion content. Batches are tested against these specifications before release. Purity specifications often require a minimum area percentage by high-performance liquid chromatography, such as 95% or 98%, depending on the intended application. Additional tests may include water content, acetate or trifluoroacetate content, and residual solvents. These parameters affect the net peptide content and the accuracy of subsequent laboratory experiments.
| Property | Value | Notes |
|---|---|---|
| Common purity specification | ≥95% by RP-HPLC | Threshold varies by application and supplier |
| Identity confirmation | Mass spectrometry | Expected versus observed molecular mass |
| Appearance | Lyophilized powder | Visual check for color and uniformity |
| Typical storage temperature | -20 °C or lower | Protect from moisture and repeated freeze-thaw |
| Counterion example | Trifluoroacetate or acetate | Residual counterion measured separately |
In March 2008, AFRL's Human Effectiveness Directorate located at Wright-Patterson AFB was merged with the Air Force School of Aerospace Medicine and the Human Performance Integration Directorate from the 311th Human Systems Wing both located at Brooks City-Base, Texas to form the 711th Human Performance Wing. In its vision statement, the wing includes the goals of improving aerospace medicine, science and technology, and human systems integration. The current Commander of the 711th is Brig. Gen. Timothy Jex. One practical application of its work is ensuring and advancing the safety of ejection systems for pilots. With the increasing number of females in the Air Force ranks, anthropometry is of greater import now than ever, and 711th's WB4 'whole-body scanner' enables swift and accurate acquisition of anthropometric data which may be used to design pilot equipment with a better fit for comfort and safety.
Acceptance sampling procedures became common during World War II. Sampling plans, such as MIL-STD-105, were developed by Harold F. Dodge and others and became frequently used as standards. More recently, quality assurance broadened the scope beyond final inspection to include all aspects of manufacturing. Broader quality management systems include methodologies such as statistical process control, HACCP, six sigma, and ISO 9000. Some use of acceptance sampling still remains.
5-HT2C receptor agonists reduce appetite by working on serotonin receptors in a region of the brain called the hypothalamus. Lorcaserin (Belviq) was FDA approved for weight loss but was withdrawn from the market because a safety clinical trial shows an increased occurrence of cancer. Cannabinoid receptor antagonists were developed to treat obesity because researchers noticed that cannabinoid agonists (such as THC, the main pharmacologically active component of cannabis), increased appetite. However, some drugs in this class such as rimonabant were withdrawn or ceased development due to concerns about mental health and suicide. More selective drugs—some are in development that act only in peripheral tissues, not the brain—may be able to achieve this result with fewer adverse effects. GLP-1 agonists such as tirzepatide, semaglutide, and liraglutide slow gastric emptying and also have neurologically driven effects on appetite. It is unknown if GLP-1 agonists or dual/triple agonists of GLP-1 and/or the glucagon or GIP receptors act solely by reducing energy intake or if they also increase energy expenditure. Setmelanotide is an agonist of the melanocortin 4 receptor and is used in people with certain rare genetic conditions that cause obesity. It is less effective and not approved for general obesity.
Pseudoacromegaly is a condition with the usual acromegaloid features but without an increase in growth hormone and IGF-1. It is frequently associated with insulin resistance. Cases have been reported due to minoxidil at an unusually high dose. It can also be caused by a selective post-receptor defect of insulin signalling, leading to the impairment of metabolic, but preservation of mitogenic, signaling. Treatment options include surgery to remove the tumor, medications, and radiation therapy. Surgery is usually the preferred treatment; the smaller the tumor, the more likely surgery will be curative. If surgery is contraindicated or not curative, somatostatin analogues or GH receptor antagonists may be used. Radiation therapy may be used if neither surgery nor medications are completely effective. Without treatment, life expectancy is reduced by 10 years; with treatment, life expectancy is not reduced.
The role of inflammation in cancer is not well understood. Some organs of the body show greater risk of cancer when they are chronically inflamed. While there is an association between increased levels of C-reactive protein and risk of developing cancer, there is no association between genetic polymorphisms influencing circulating levels of CRP and cancer risk. In a 2004 prospective cohort study on colon cancer risk associated with CRP levels, people with colon cancer had higher average CRP concentrations than people without colon cancer. It can be noted that the average CRP levels in both groups were well within the range of CRP levels usually found in healthy people. However, these findings may suggest that low inflammation level can be associated with a lower risk of colon cancer, concurring with previous studies that indicate anti-inflammatory drugs could lower colon cancer risk.
Sources: en.wikipedia.org
Bone morphogenetic proteins (BMPs) are a group of growth factors also known as cytokines and as metabologens. Professor Marshall Urist and Professor Hari Reddi discovered their ability to induce the formation of bone and cartilage, BMPs are now considered to constitute a group of pivotal morphogenetic signals, orchestrating tissue architecture throughout the body. The important functioning of BMP signals in physiology is emphasized by the multitude of roles for dysregulated BMP signalling in pathological processes. Cancerous disease often involves misregulation of the BMP signalling system. Absence of BMP signalling is, for instance, an important factor in the progression of colon cancer, and conversely, overactivation of BMP signalling following reflux-induced esophagitis provokes Barrett's esophagus and is thus instrumental in the development of esophageal adenocarcinoma. Recombinant human BMPs (rhBMPs) are used in orthopedic applications such as spinal fusions, nonunions, and oral surgery. rhBMP-2 and rhBMP-7 are Food and Drug Administration (FDA)-approved for some uses. rhBMP-2 causes more overgrown bone than any other BMPs and is widely used off-label.
Feoktist I. Bogoyavlenskiy (1933–1935) Vasiliy V. Evlampiev (1935–1939) Faizi F. Faizyllin (1958–1960) Boris A. Arbuzov (1941–1950) Arkadiy N. Pudovik (1950–1958) Faizi F. Faizyllin (1958–1960) Vera F. Toropova (1960–1965) Alexander I. Kostromin (1965–1968) Alexander I. Konovalov (1968–1972) Irina V. Konovalova (1972–1987) Galina A. Chmutova (1987–1992) Nikolai A. Ulakhovich (1992–2000) Vladimir I. Galkin (since 2000– until present) Department of Analytical Chemistry Department of High Molecular and Organoelement Compounds Department of Inorganic Chemistry Department of Organic Chemistry Department of Physical Chemistry Department of Chemical Education Department of Environmental Chemistry Department of Applied Chemistry Department of Stereochemistry Division for Analytical Chemistry Division for Inorganic Chemistry and Coordination chemistry Division for Organic Chemistry Division for Physical Chemistry Division for Organoelement Compounds Division for Stereochemistry Division for Applied Chemistry Division for Environmental Chemistry
Similar structures include the 310 helix (i + 3 → i hydrogen bonding) and the π-helix (i + 5 → i hydrogen bonding). The α-helix can be described as a 3.613 helix, since the i + 4 spacing adds three more atoms to the H-bonded loop compared to the tighter 310 helix, and on average, 3.6 amino acids are involved in one ring of α-helix. The subscripts refer to the number of atoms (including the hydrogen) in the closed loop formed by the hydrogen bond.
Lipid vesicles or liposomes are approximately spherical pockets that are enclosed by a lipid bilayer. These structures are used in laboratories to study the effects of chemicals in cells by delivering these chemicals directly to the cell, as well as getting more insight into cell membrane permeability. Lipid vesicles and liposomes are formed by first suspending a lipid in an aqueous solution then agitating the mixture through sonication, resulting in a vesicle. Measuring the rate of efflux from the inside of the vesicle to the ambient solution allows researchers to better understand membrane permeability. Vesicles can be formed with molecules and ions inside the vesicle by forming the vesicle with the desired molecule or ion present in the solution. Proteins can also be embedded into the membrane through solubilizing the desired proteins in the presence of detergents and attaching them to the phospholipids in which the liposome is formed. These provide researchers with a tool to examine various membrane protein functions.
AAV is of particular interest to gene therapists due to its apparent limited capacity to induce immune responses in humans, a factor which should positively influence vector transduction efficiency while reducing the risk of any immune-associated pathology. AAV is not considered to have any known role in disease. However, host immune system response and immune tolerance reduce the efficacy of AAV-mediated gene therapy. Host immune response has been shown to respond to the AAV vectors, the transduced cells, and the transduced proteins. The immune response can be subdivided into two categories: innate and adaptive, the latter of which is divided into humoral and cell-mediated.
Sources: en.wikipedia.org
Several approaches have been developed to analyze the location of organelles, genes, proteins, and other components within cells. A gene ontology category, cellular component, has been devised to capture subcellular localization in many biological databases. Microscopic pictures allow for the location of organelles as well as molecules, which may be the source of abnormalities in diseases. Finding the location of proteins allows us to predict what they do. This is called protein function prediction. For instance, if a protein is found in the nucleus it may be involved in gene regulation or splicing. By contrast, if a protein is found in mitochondria, it may be involved in respiration or other metabolic processes. There are well developed protein subcellular localization prediction resources available, including protein subcellular location databases, and prediction tools.
Calcitonin gene-related peptide 2 (CGRP2), also called calcitonin related polypeptide beta, is a hormone that in humans is encoded by the CALCB gene (previously CALC2). Like the related hormone, calcitonin gene-related peptide 1 (CGRP1), this hormone induces vasodilation (relaxation of blood vessels) through the activation of the CGRP receptor. This form of calcitonin gene-related peptide is traditionally considered to be the primary form used in the enteric nervous system (nervous system in the gut). The gene that encodes CGRP1, CALCA, also encodes the blood-calcium-reducing hormone calcitonin, but despite its name, this protein is encoded by a distinct gene (CALCB). This hormone activates the CGRP receptor, which is a two protein (heterodimer) complex that is composed of RAMP1 and CALCRL.
A property of DNA is its ability to re-anneal into double-stranded molecules when pH conditions are neutralized. Under neutral conditions, hydrogen bonds reform between complementary base pairs. Because the plasmid was so tightly coiled and small before the alkaline conditions were established, it can easily re-anneal. The chromosomal DNA, however, because of its lengthy strands, does not re-anneal. Once the plasmid DNA reassociates into double-stranded molecules, it dissolves into the solution. Potassium acetate reacts with the SDS detergent, magnesium ions, and calcium ions already present in the solution and forms potassium dodecyl sulfate (KDS), an insoluble white solid which precipitates out of solution. The remaining chromosomal DNA strands, denatured proteins, and added chemicals stick together and precipitate out with the KDS. The plasmid DNA, however, remains dissolved in the liquid solution. The solution is usually centrifuged to collect the insoluble precipitates into a debris pellet at the bottom of the sample tube and thereby isolate them from the supernatant.
The LCPO method uses a linear approximation of the two-body problem for a quicker analytical calculation of ASA. The approximations used in LCPO result in an error in the range of 1-3 Ų. In 2011, a method was presented that calculates ASA fast and analytically using a power diagram. Accessible surface area is often used when calculating the transfer free energy required to move a biomolecule from an aqueous solvent to a non-polar solvent, such as a lipid environment. The LCPO method is also used when calculating implicit solvent effects in the molecular dynamics software package AMBER. It is recently suggested that (predicted) accessible surface area can be used to improve prediction of protein secondary structure.
Sources: en.wikipedia.org
It is a document reporting test results for a specific lot, often including appearance, HPLC purity, mass identity, and storage conditions. It should identify the analytical method and acceptance criteria. The certificate describes the tested sample, not necessarily every vial.
Not necessarily. HPLC purity reflects relative ultraviolet absorbance under one set of conditions. A peptide with high area percent may still contain a biologically active impurity or have poor solubility.
Comparisons require the same method, wavelength, gradient, and integration rules. Results from different laboratories may not be directly comparable. Reporting the method alongside the value is essential for interpretation.
Lyophilized peptides are typically stored at -20 °C or lower, protected from moisture and light. Solutions are often stored at -80 °C and divided into single-use aliquots. Repeated freeze-thaw cycles should be avoided.